|
|
|
|
|
|
|
|
|
|
|
Author |
Message |
|
|
Thu Jun 29, 2006 10:28 am |
I have just started using the ADCE and Prep products. I cleanse, tone, apply the prep and wait a few minutes, then apply adce to the facial areas with fine lines (most of my face, unfortuneately!). I wait for about 10 minutes and them apply my Dermalogica tinted moisture spf 15. I am having a problem with the tinted moisture glopping up and not being absorbed evenly. I ended up having to wipe my face with a dry face cloth. This didn't happen before with my regular dermalogica routine. Any suggestions? (I am 48 with pale moderately cuperous skin with dry areas and areas with enlarged pores on nose and chin) |
|
|
|
|
Thu Jun 29, 2006 7:37 pm |
I had this problem also, then I read to give the JB products more time to be absorbed into your skin. It works! |
|
|
|
|
Fri Jun 30, 2006 5:18 am |
I found that a little bit goes a long way. When I first started using the prep it would sometimes cause my next step to "ball" up. Once I cut back on how much to apply & then waited for a short time longer, it was perfect. (And still is!) |
|
|
|
Thu Mar 28, 2024 2:54 am |
If this is your first visit to the EDS Forums please take the time to register. Registration is required for you to post on the forums. Registration will also give you the ability to track messages of interest, send private messages to other users, participate in Gift Certificates draws and enjoy automatic discounts for shopping at our online store. Registration is free and takes just a few seconds to complete.
Click Here to join our community.
If you are already a registered member on the forums, please login to gain full access to the site. |
|
|
|
|
|